Posted by jimb2 on August 27, 2014 at 19:20:08 from (99.241.118.87):
In Reply to: Re: 684 ih posted by Jerry Gilliam on August 27, 2014 at 13:32:30:
Hi Jerry, you can test the tach by using a cordless drill connected to the end of the tach drive cable. Just make sure you have the drill turning in the correct direction.
The problem is still probably the drive mechanism. I am 65 years old and it was more than 15 years ago that I repaired the drive mechanism. If I recall there was a pressed in end opposite the tach cable end and I had to remove it and inside the shaft that ran the tach cable ran off a worm gear and the shaft end was held in correct position by a fiber spacer as the fiber spacer wore the shaft was allowed to push away from the driving gear and the shaft stops turning. I fixed it by adding a metal spacer and resealing the end cap.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.