Posted by fixerupper on August 27, 2014 at 08:07:21 from (216.16.93.75):
Splines are getting loose on the tie rod arms on the top of the front wheel spindles on the 1086. This is a loader tractor. Is there anything available out there that is better than the straight splined spindle and arm the factory offers?
A local machine shop used to slit the arm at the splines and weld on a couple of stubs with holes to put a cross bolt through to clamp the arm tight on the splines. I had that done to the factory arms and it did clamp well onto the splines but the cross clamping bolts broke from the extra stress on the steering when I had saddle tanks on the tractor. A loader is worse than saddle tanks.
The other day this tractor was a little squirrelly going wide open down the road. Upon investigation I found the top trunion bolt gone from the steering cylinder and the bottom bolt half out. I don't get this tractor into high gear often so I don't know how long the top bolt was out before I discovered it. I could have very easily had a wild ride into the ditch if that bottom bolt would have dropped out. Ouch! Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.