Farmall & IHC Tractors Discussion Board |
Re: Re: Re: identity ???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by George Willer on January 01, 2001 at 06:42:28 from (205.133.30.80):
In Reply to: Re: Re: identity ??? posted by Josh on December 31, 2000 at 20:43:43:
Josh, Your life is too sheltered! If it can be done to a Cub, why not an A? The project is not very far along yet, but plan to see at it a lot of shows next year. The rest of the tractor will be built from my parts inventory. Follow the link below to see progress so far. Converting an A into a B would be simpler, since the correct length axles exist. For the Cub conversion, the left axle will have to be lengthened 1", or the housing shortened. Back to the original question...the overall width should rule out a BN as it would be narrower. The mystery tractor must be a B. George
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|