First off, confirm again you are talking about a 340 Farmall, not a Utility. The steering is totally different. If you have nothing better for a reference, go to the CaseIH online Parts Store and look at the exploded parts diagram.
Do "find parts by model", search for "340", click on Farmall Tractor, click on "steering mechanism", click on 340 Farmall.
I've never worked on the steering on a 340, but I believe it is essentially like a 240. If so, the advice you have already gotten is all good, with one possible exception. I don't think there are any keys inside that mechanism. I think the worm gear is integral with the input shaft and the sector gear is splined to the output. There is a key where the universal joint goes onto the worm shaft. So check that before you take anything else apart. Otherwise, you still need to pull it apart as Gene described. If you have to replace gears, be aware that the tractors originally with a wide front had a different ratio than those with a narrow front. Replacement gears will have to match up properly so you may have to get both gears from a donor unit.
You will probably want to put in a new bottom seal when you reassemble.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.