Posted by Mr. Farmall A on August 01, 2014 at 10:34:47 from (68.32.185.8):
My 1946 Farmall A has blown it's 3rd head gasket in 5 years. I only use it for mowing with a 5 foot wide pull behind rough cut mower. I have been mowing with this tractor for 13 years now. About 5 years ago the old head gasket blew, motor still ran but the crankcase would fill up with coolant and smoke badly. Took the head off, installed a new head gasket with copper sealant, torqued the head to the revised IH specs, then retorqued it warm. After 2 years it blew again, so I checked the head for flatness and sure enough it was warped. Had it milled flat again and repeated the install. After 1 and a half years the head gasket just blew on me again today, just started pumping out white smoke like a steam engine.
The motor doesn't seem to be overheating, but thinking back it seemed to be slowly losing a little power over the summer. Could it be the copper gasket sealant? The head gasket instructions said to use it but can that stuff be failure prone? I also had to replace a shim head gasket in my small block Chevy 6 years ago and it is still holding up fine and I did not use sealant on that motor. Any other throughts? Is it just common for head gaskets to not just last that long on these tractors? Are some brands of head gaskets just better than others? Maybe the deck on the block itself is warped? Does the A need to be jack supported in a special way while the head is torqued since the block is also a load bearing member? Just really stumped by so many failures.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
