Posted by HillBillyRockStar on July 27, 2014 at 20:17:00 from (70.210.70.213):
Putting new clutch in a M. Went from a 11" clutch to a 12". Flywheel from a 400. Flywheel resurfaced, New pilot and throwout bearings, reman clutch disk and pressure plate. Went together easy till rear engine plate was a 1/4" from bell housing. Pulled it back apart pressure plate hitting belly pump tank. Tractor has the live hydraulic pump on it, using belly pump as tank. Pressure plate is not splined like a T/A tractor. Pilot bearing fit imput shaft. Spline's on clutch disk fit also. So 1 of 3 things is going on. #1 12" clutch won't work in a tractor with a belly pump? #2 I ordered or using wrong clutch parts combination? #3 I ordered correct parts got sent wrong one's? Y'all the experts what did I do wrong?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.