There is NO set number of shims on each side of the differential or on the pinion. If you have to start over from scratch as you did not keep track of your shims, here is what you do. Install differential with equal thickness of shims on each side with pinion removed. . Add or remove shims until you have no side load on bearings which you will determine by having just a little bit of side movement of differential, like .010(as these are ball bearings and cannot be loaded). Now you install pinion with enough shims so the butt end of pinion and ring gear are flush. You will have to shuffle shims back and forth on differential to obtain that. Now, you want (this is if gears are new) about .006 to .012 back lash between ring and pinion gears. This is measured with a dial indicator on the very tip of ring gear tooth with pinion held solid. You will need input shaft installed also so pinion is in normal operating position.
But , here comes the rub. You are working with used gears that have established a pattern. To get back to that same wear pattern is very difficult. When I tear one down that I intend to reuse gears I measure the backlash before removing unless of course a bearing is completely shelled out. Even if there is a lot of back lash, I attempt to reset to same when putting it back together.
You can use tooth contact readings with Prussian blue or grease , or some other suitable material but you have to have the experienced eye to know what you are looking for. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
