Farmall & IHC Tractors Discussion Board |
Re: 560 D hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sam on December 29, 2000 at 10:55:49 from (129.82.219.17):
In Reply to: 560 D hydraulics posted by JMylar on December 29, 2000 at 10:27:28:
With respect to entry points I would suspect condensation, unless you have a bunch of water in there. Seems like the gear shifting level is pretty well protected by the metal flange. I drained a 560D that had sat out in the weather for 11+ years and got about a pint of water (keep in mind that is 11 years of semi arid Colorado weather). The water will be at the bottom - you might try draining it plus a bit of the hydraulic fluid after the tractors has been sitting unused for a good stretch of time (11 years did the trick!). I got water from both the front and rear drains, so keep that in mind. Others might be able to tell you if water will seperate from the fluid or if it stays suspended like mayonaise.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|