We had problems with shear pins too on ours when I was helping pop. I seem to remember we would have to check the bale tie mechanism once in a while too. When we were using it in the 70s and 80s, if the shear pin sheared, we would replace it and check the knotter by forcing it to tie early. There is a bar on the back that you can pull up which activates the knotter. Our bales were the small type but we set them to about 100 lbs per bale. We also slowed down if the hay was binding too much. Too much hay in the chamber also made the shear pin on the fork to shear. We broke open the small bales we made testing the system and rebaled them into regular sized 2 wire bales. Those were the 57 and 55 IH balers we had. A little story, we had and issue with hay not going into the chamber after being pulled up by the sweeper front. I think it was either my dad or gpa that took a shovel and pushed the hay a little way into the chamber and the shovel went into the chamber. That shovel became a corrigate shovel pretty quickly. We took that bale apart and framed the shovel and all 4 pieces of handle with it as a guide as to what not to do.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.