Posted by Sparky70 on July 02, 2014 at 15:23:35 from (74.118.207.167):
In Reply to: Broken Whip Mower posted by Sparky70 on June 30, 2014 at 17:51:25:
Well the bar is 1 and .125 one side and 1 inch other. The broken piece slipped out with a little help. I seen what appeared to be replacement bars at tractor supply so I am off to see them in a day or two. Evidently different whip mower manufactures assembled pto shafts as they seen fit. Thanks to all that contributed, I am better informed.
This "Joint" should be a slip joint and the remainder of the square shaft should pull out once you get the twisted shaft started out of the end slightly. Check the shaft for being square or about 1/8 inch more in one dimension? They will have one dimension a little larger and cannot/should not go together but one way. This keeps the universal joints aligned. Be careful to repair the shaft in the correct alignment.[/quote]
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.