"I think next I'll do the "motor" test on the generator. From what I'm reading, if I can run the generator as a motor it should charge."
ACTUALLY, its my opinion that its ONLY if it passes BOTH Motor Tests (see my Troubleshooting Procedure below) it should charge. The first shows if the armature and brushes are good while the second shows the field windings condition.
"What about the cut-out relay? I see various posts about VR's, how does one go about testing the cut-out relay?"
If the cutout relay is working (a VR also has a cutout relay inside it remember) when the tractor isn't running there would be hot battery voltage on the BAT terminal but none on the GEN/ARM terminal (unless its stuck closed). Then once running iffffffffff the genny and all else is wired correct and working, the normally open relay closes so theres voltage on BOTH the BAT and GEN/ARM terminals, but once shut down the relay if working should open.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.