Farmall & IHC Tractors Discussion Board |
Re: Re: Cub Head Gasket
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Red Raider on December 27, 2000 at 18:52:38 from (208.188.20.8):
In Reply to: Re: Cub Head Gasket posted by Andy Martin on December 27, 2000 at 15:29:45:
It's not the radiator hose, tiny beads of coolant collected in about an hour at various places around the head/block interface. I'm absolutely certain of a precision machined head. I know the fellow very well. I used the IHC repair manual on the C-60 to C-284 engines for torque sequence at 45ft/lbs. If the problem was one or two spots, a ding might be it, or a milled sand cavity, but it's all around the head. I'm stumped on this one. Could it be a defective head gasket, or serius block warp? Pulled the head tonight and found some moisture around the valves and 2 cylinders. Dried quickly and now the rings are clear with motor oil.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|