This is for a rowcrop 300 or 350, haven't done a 300U engine.
To install 300 or 350 engine in a H
1. If you are planning on using the 300/350 live pump be sure to use the timing cover and related parts for 300 or 350, SH or late H (older H bolt holes are different).
2. Use the H fan, 300/350 fan is to large in diameter.
3. Use the air cleaner & pipe from air cleaner to carburetor for a SH, the one for an H is to small for the 300/350 carburetor.
4. Use a 300/350 or SH flywheel and a SH clutch plate and pressure plate if you are going to pull it hard (H flywheel, clutch plate and pressure plate will work but is smaller, H 10”, SH/300/350 10 ½” ).
5. Use H governor or use throttle shaft from H governor in 300/350 governor.
6. Have to convert vent from back of head on H to vent from valve cover for 300/350.
7. Change oil pressure fitting from H onto 300/350 block before installing side rail channels (fitting is hard to change after rails are installed).300/350 had small line from block to gauge.
This post was edited by Dave S. at 12:41:00 06/25/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.