Farmall & IHC Tractors Discussion Board |
Capping hydraulic lines
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sam on December 27, 2000 at 18:41:04 from (216.17.135.111):
I have a 560D which originally had the 2pt hitch. The metal hydraulic supply lines run across the top of the plate where your feet rest, into the tool box under the seat, and out the back. When the tractor had a 3pt conversion, these lines were capped at a junction box under the seat. Recently I felt the urge to remove all the old dirt and rusted bolts from the tool box, but now I have a hydraulic leak from a rusted spot in the line. Ideally I would totally remove the lines, right back to the top of the control valves. However, this looks like it requires removing the fuel tank, batteries, the bracket which holds the tank and the batteries, some of the throttle linkage, and then the bracket which holds the steering column. Does it sound reasonable to cut out the rusted portion of the lines and thread them for a cap until some later date when I'm up to dismantling? It appears the lines were welded to the rear junction block - would it be a safer bet to try to weld a cap on the cut lines than to cut threads? Any suggestions would be greatly appreciated! Sam.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|