Posted by D Slater on June 18, 2014 at 07:40:00 from (184.14.183.67):
In Reply to: H pistons and sleeves posted by oldiron29 on June 18, 2014 at 07:11:46:
H through 350 engines used two crankshaft rod and main sizes and one size on the rod big end. Just match the bearings to the crankshaft size. Example rods from a 300 on a small journal H crank use H bearings that are sized for the crankshaft. Two rods were used H, SH, and part of the 300 with piston pin size being the difference between them and later 300 and all 350 engines. Big came on part of the 300 engines until a serial # break and small pin after.
Big pin rods can be used with small pin pistons using pin adapter bushings. Small pin rods won't work with big pin pistons.
If the 300 had 3-7/16 sleeves in it the block must be a H. 3-7/16 ID sleeves won't work in a C-169 300 block.
Should be 3.5 or 3-9/16 ID sleeves on a 300.
Messed up, C-169 would have 3-9/16 or 3-5/8 ID sleeves. Other I posted is a C-164 SH size.
This post was edited by D Slater at 12:19:17 06/18/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.