Posted by Jim Stordahl on June 13, 2014 at 08:26:05 from (66.219.8.179):
Over the years, I posted questions of problems with my “experienced” tractors and you have never failed to solve the problem. I have another one and hope you help solve this mystery.
I have a 1948 M with a 325 Dual loader, Schwartz front end with full PS and an add-on two speed splitter which gives me the ideal forward and reverse speeds for picking up round bales after harvest – it’s primary job around the farm. It’s a perfect job for this tractor and I love being in the fresh air after baling.
Here’s the problem… The engine does not run smooth. When it idles, it sounds like its missing, it’s a bit better a low-mid range rpm, worse at higher rpm. When I put it under a bit of a load (I grab a bale and take off quickly, going uphill), it seems to smoothen out and sounds like it’s hitting on all four. When the “pressure” is off, it’s back to running uneven.
I have changed plugs (not wires), which has not helped. I have gone through the carb, no difference. Someone suggested a bad valve so I checked compression on each cyclinder – all four are equal, all hold (for at least 10 sec) and have about 80 psi – so not sure if it’s a sticky valve. Is this a correct assumption?
Another clue… The temp guage shows it runs cool, and I assume the guage works. If I forget the winter cover on front, it will get hot. When I get the temp up, it does seem to run better. When I’m in the field, the guage shows it to be below normal temps. Could I have a bad thermostat? Would that explain the symptoms?
Someone else suggested a leak in intake manifold, would that create these symptoms? Could it be multiple problems? Any other ideas?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
