Posted by Centex Farmall on May 20, 2014 at 21:19:28 from (72.105.165.109):
In Reply to: M leaks posted by Johnny Meloy on May 20, 2014 at 19:04:08:
It's heavy but can be handled if you're expecting it. You will need a pry bar or board between the front of the belt pulley and the torque tube. Get the area all the way around it as clean as possible. A thin screwdriver and compressed air are great. Dirt loves to accumulate between the unit and trans and will do everything possible to fall in the trans when you take the belt pulley off.
With the 4 shorter bolts out and the two long ones sitting loose in the holes, start wiggling the unit with your prying tool. There is a dowel on each side that is putting up a small fight at this point. A giant screwdriver is useful at this point both in encouraging separation of the unit from the trans and as a spacer to keep it from plopping back down once it pops loose.
With a little encouragement the unit will come loose but sit there. Get your gloves and stand on the pulley side and reach across with your left hand for lift on the far side and your right under the pulley part of the near side. Go up as much as you can and then start backing up. You've got it from then on.
Have somewhere ready to go with it that's at table height! A piece of cardboard to set it on is perfect and will keep the gear from getting dinged when you first set it down.
Now you can also get a good look at the inside of the transmission.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
