Posted by Bob on May 19, 2014 at 19:23:51 from (75.238.189.14):
In Reply to: farmall 560 regulator posted by farmall560guy on May 19, 2014 at 18:55:42:
Is the charging system working?
The reason I ask is that there is typically a flexible, braided copper wire that jumpers from the regulator frame to the tractor chassis mounting area where the rubber mounts attach, and once this breaks the charging system no longer charges.
I suppose, if you are mechanically adept, you cold bolt some new strips of rubber belting in place of the (rotten) factory stuff and save the cost of a regulator.
Otherwise, you are stuck for a new one.
Regulators do NOT need to be polarized. EVER. Under certain circumstances, generators DO. (If they've been dis-assembled or sat unused for YEARS.)
Often, this is done at the voltage regulator, for easy access to the necessary terminals/voltage.
Since this is a Delco "A" circuit system, momentarily jumping "BATT" and ARM (or"GEN) at the voltage regulator will polarize the GENERATOR.
Which you should NOT need to do, if simply replacing the VR.
But, if done as directed, it won't HURT anything IF you polarize the genny.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.