LenNH said: (quoted from post at 14:03:53 03/13/09) As far as I know, the "gas manifold" that comes through the hood was never an original option. I would bet that it is the same manifold that you could buy for an F-30. .......................
.......I hope you can use the manifold in original configuration. I hate to see a restored tractor that's been cut up the way you have to do to put on the vertical exhaust pipe.
Well put LenNH! I sure hate to see a cold manifold [or a variable governor] put on one that still had the original, especially if the hood is in good shape. If it was already there, it makes sense as a "historical feature" too, but it seems the numbers are few enough of the Kerosene and combination manifolds around compared to the cold ones I sure like to see originals. There is supposed to be some power gained by the carb/manifold combination; likewise the variable governor is nice, but if there are no originals around it's hard to appreciate the updated ones or even know there was a difference.
I believe there may have been a special purpose version [like industrial, orchard, etc] that could have used a cold manifold. Power units likely did too; else I don't think 10-20s ever had a cold manifold [exhaust through the hood, and "updraft" carburator] as supplied. The 22-36 had a manifold with selectable baffles [early 15-30 I believe were near identical to the one in Dave's picture], and maybe Dave's 10-20s had similar arrangements, but the one pictured looks like the Kerosene type without selectors to me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.