Posted by Janicholson on May 04, 2014 at 12:42:13 from (74.60.94.18):
In Reply to: Pto update posted by Farmall4856 on May 04, 2014 at 11:26:16:
I believe (and you will take a good look) that the handle is loose on the shaft where the bracket and small lever are attached. There is a woodruf key on the handle and the shaft can wallow that out and allow the handle to move one degree or so before the shaft turns. That is enough to make the travel short. To check it you must move the handle through its full range while feeling it or looking carefully while moving the lever, as it only slips while near either end. Do not tighten the nut extra tight it will destroy the threads before making a difference. The Keyway should be ground out to the next larger size and the key slot milled or broached to match. Very careful use of a dremel will work if you are good. (or take it to a machine shop. It is a weak point in the linkage. If the lever is not loose, tighten the "on" band 1/4 turn and see if it works, or adjust the center linkage a tiny bit longer if it has a threaded adjustment (I think some do). (one thread) Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
