Posted by rhtx55 on April 30, 2014 at 17:06:55 from (68.185.207.25):
In Reply to: steering bushing posted by kathy massart on April 30, 2014 at 15:46:52:
Measure the shaft diameter where the bushing goes & then measure the inside diameter of the new bushing. Most original shafts have quite a bit of wear. Best choice would be to have an oversize bushing machined to just fit your existing shaft, if the shaft has a lot of wear, turn it smooth first, then measure for the oversize bushing.
Steering shaft Ujoints, Worm & pivot gears, worm bearing, wheel bearings all contribute to steering play in the steering wheel. It has been my experience the sooner you replace them all (as one can afford) the better the steering will be.
I have an F300, over time I replaced steering shaft (with gear), worm gear ( full round), steering shaft bearing ( in upper bolster), steering shaft bushing ( in steering tower at platform), steering shaft u-joints, wheel bearings & seals, upper & lower bolster bushings
(had oversize ones machined to fit the turned down original shaft) where the bushing ride, new felts & seals, new thrust bearing ( had the lower bolster machined smooth for it to ride on). You can now turn it stop to stop just by using the spinner. In road gear no wobble & it steers with just a finger.
Wasn't cheap, but was much cheaper than trying to put power steering unit on it !!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
