Posted by rhtx55 on April 22, 2014 at 16:35:34 from (68.185.207.25):
In Reply to: Freeing a stuck motor posted by James Williams on April 22, 2014 at 05:45:08:
Caustic soda &water, when I worked for Cummins Overhaul facility in the late 70's we had different tanks with separate "recipes" for cast, steel & aluminum. Cast parts usually soaked for at least 12 to 18 hours. Once the parts were removed using a small overhead crane, as the parts were placed onto fabricated steel mesh racks, and washed with very hot pressurized soap & water. No rust, paint, or any oil residue was left on the parts.
We had to wear protective clothing , facemask, gloves & rain gear to keep any residue off our skin, believe me, you only did that one ONCE, by the time you felt the burn it was too late, you could seriously scar your skin if you did not neutralize, and wash it off immediately
The tanks were hot enough to steam constantly & had a circulating pump in each one. Once or twice a year they were all drained and the sediment (yuck) was cleaned out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.