Farmall & IHC Tractors Discussion Board |
Re: Rear duals on H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny on December 22, 2000 at 22:56:14 from (216.165.148.189):
In Reply to: Rear duals on H posted by Jim on December 19, 2000 at 20:28:52:
I'll echo most of the comments of those before me, and stress that "Clamp-On" duals were NOT recommended for the wheels on H's & M's. The cast centers would crack through the centers. Duals were actually for flotation on soft plowed ground. Traction was also increased and they do ride better. If the tractor feels like it's getting close to rolling over, GET OFF THE HILL. IH only ever sold direct axle mount duals, even after they came out with the wedge-lock wheel, which was strong enough for clamp-on duals. Dad & I had clamp-on's on our M and Super H but only for planting corn. The heavy work with the M-TA and 450 was done with axle mounts. Unless you need flotation on soft dry ground, just set your wheels wider. Duals DO NOT get you over soft WET ground. I've been stuck Way too many times during wet springs, duals just get you too far into trouble!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|