Posted by pete 23 on April 18, 2014 at 10:28:46 from (74.33.94.238):
In Reply to: 1486 reverse problem posted by big1486 on April 17, 2014 at 15:56:47:
I see no one has responded to your problem. Here is what is going on. The shift collar on reverse is going too far and slides up on the splines of driven gear so far it comes disengaged from driving gear. Usually caused by worn or broken fork, or key way in reverse shift lever shaft. May also be caused by too much end play in the reverse shaft assembly. Some times the washers between the gears break, wear out or wear into the rear housing. One other thing is wrong gasket installed between speed transmission and range transmission allowing shaft to move forward a little. Need to take off side fuel tank to remove side cover to take a look. Then run over that tank so you can't put it back on and save everyone who ever has to do any work on the tractor a lot of headaches.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
