Posted by D Slater on April 18, 2014 at 06:11:41 from (184.14.205.2):
In Reply to: Re: throttle lever posted by Farmall4856 on April 18, 2014 at 04:47:06:
Unless someone changed things on the F300. Should have one flat washer and a lock washer and bolt retaining them to the throttle lever. If its the original washer and fits the notches it can be rotated to go in the notches at a different area. If the notches are okay the next area to check is where the throttle lever attaches to the throttle rod. Check condition of the holes and pin. In front of the throttle lever should be a washer, a spring, another washer and a pin through the rod or a C clip. If that's all okay, at the rear end of the throttle rod the handle goes to is a pin or a C clip. If this pin or clip is missing or worn off like some, it will let the throttle rod shift forward and loose some spring pressure pushing the throttle lever in the notches. Washer that goes in the notches from what I remember is not standard. Its a 1/4 inch washer but about the size of a 5/16 uss on the OD and thicker than a 1/4 one.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.