thanks everybody for your input. sounds like to me i need more than just the plow and the drawbar cause thats all i got. there is a chain hooked to the back of the plow to hook to the lift arm that i'm pretty sure lifts the plow. there is another chain that is hooked to the plow about mid-way that i think hooks to the right rear of the final drive for maybe depth control?..so i believe i understand that the draw bar is to be turned around backwards and hooked to the front set of holes on each final drive. when i say front set of holes i am talking about each final drive has 2 sets of 3 holes on each final drive 1 set of 3 on the front of the final drive and 1 set of 3 on the rear of the final drive. i should hook the draw bar to the set of holes closes to the front of the tractor. the brackets that mount to the final drives stay put when mounted to the finals but the draw bar it self mounts to these brackets with 2 bolts on each side of the draw bar but i need to take one bolt out of each side of the draw bar to mounting bracket so the draw bar can pivot and allow some angle to the plow point to allow it to angle into the ground and that angling is what makes the plow go into the ground....i think...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.