Farmall & IHC Tractors Discussion Board |
Re: Snow Blade for a H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on December 21, 2000 at 18:11:32 from (216.196.12.225):
In Reply to: Snow Blade for a H posted by Scott on December 21, 2000 at 16:47:43:
I made up a plow for my S/H from a old 7 foot western snow plowthat i had laying around, iused some 4 inch channel to make the main frame some two and half inch pipe to go to the mounting holes on the sie of the tractor two and half buy quarter angle iron for the frount support bracketsto the ft. bolster ,i used one of the old angle cylinders for the lift and ran it off of the tractor hdys.took about five hours to build. It will realey push snow, the only problem is that the heater does not work!!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|