Posted by farmallhal on April 02, 2014 at 16:46:30 from (76.2.172.199):
Got my Farmall 240 to the point I had it running this morning. Have a small problem with the hook-up of the metal line to the gauge. The original gauge to the tractor opening on the back is somewhat larger then the new gauge I am replacing it with. I'm using the brass connector between the gauge and the pressure line. I believe the hole in the back of the original gauge would permit the end of the pressure line to enter the gauge slightly. The replacement gauge is too small and I believe the tube is bottoming out on the gauge. When tightening the nut against the ferrule I believe I am not getting it seated correctly to the gauge. I might have a problem in that the original pressure line needs trimmed off a small amount so the retaining nut can tighten and seal the ferrule to the brass connector. Or maybe the back of the gauge needs opened up slightly so the line can seat instead of the existing interference on the gauge. Has anyone run into this issue and what is the proper resolution - gauges are either NOS or obtained from CaseIH. Any solutions or comments are greatly appreciated, Hal.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.