Posted by Red Mercury on March 28, 2014 at 22:42:36 from (204.112.17.140):
In Reply to: What is a W9 worth? posted by T in NE on March 27, 2014 at 09:40:32:
2pipe said: (quoted from post at 04:01:58 03/29/14) FYI That live hyd pump off of your W9 won't fit on an M, it is too big and the bolt holes aren't in the right places.
I suspected the same thing. Years ago, I measured a WD-9 pump with the intention of putting it on a WD-6 .it looked like it should fit ..but the mounting holes were not where they needed to be. I would bet that a W-9 to M hydraulic pump transplant would have the same problem.
As for the aftermarket websites that say it should fit, they often have errors in the list of applications. The safest bet is to check the part numbers in the original IH parts manuals and see if they match.
This post was edited by Red Mercury at 22:44:37 03/28/14.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.