Farmall & IHC Tractors Discussion Board |
Re: Need Advice on Super A 3-point
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom Olson on December 19, 2000 at 21:12:41 from (206.190.9.92):
In Reply to: Need Advice on Super A 3-point posted by Fred Miller on December 19, 2000 at 19:29:30:
Hi Fred, I had the same concerns. A phone call to Central Tractor was very helpful. They were good enough to copy the manual that comes with the hitch and send it to me. Looking at the actual manual answered the questions/concerns I had so I bought the 3-pt conversion Model HK-95 from them. Price at the time (Aug. or Sept, 2000)was $350. It's made by "Worksaver, Inc." of Litchfield, Il. It uses the existing hydraulic lift on the tractor to raise and lower the 3 pt. hitch. My Super A has the rear lift assembly mounted on the rear wheel fenders behind the operator's seat. The rear lift assy. is operated by a linkage on the left side of the tractor going forward to the left lift arm on the hydraulic lift system. The mounting plates for the hitch bolt to where your existing factory drawbar fastens to the tractor housing. The whole unit is "bolt-on" and no modifications or changes to the tractor itself were required. It is well built and ample strong for anything I would connect to it. I will try to scan in the exploded parts view and send it just to you as an attachment to an e-mail. Tom Olson
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|