Farmall & IHC Tractors Discussion Board |
Re: IH 966 won't pull on grade
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Redfan on December 19, 2000 at 12:40:09 from (203.87.53.9):
In Reply to: IH 966 won't pull on grade posted by gilberth on December 19, 2000 at 05:59:48:
That lever on the left is your TA lever, forward for high and back for low. Low is about 25% slower than high. High is driven through a hydraulic clutch and low is driven through a mechanical sprag clutch. I think you'll find the sprag clutch has failed, hence no low, and your MCV pump which supplies hydraulic pressure for high range badly needs rebuilding. Hence slippage in high, under heavy loads. Explains also, why your brakes aren't much good. MCV pump repair is simple once you remove it from the side panel where your TA lever connects to. This will give you high TA power again. To repair sprag clutch, will mean splitting tractor and installing new TA. If you go this way install the new style mechanical diode TA. Regards, Redfan.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|