They (on those I have seen) were on the left front corner of the primary frame. The bracket was 3/4" thick plate bent into a U shape with the wheel mounted on an adjustable J shaped bar that could be slid in from the bottom. Ours was set to depth, but not used as a primary support on the land. It was used as a visual cue as to the current depth, as was the cylinder lmit collar. With a handle operated psudo draft control, (D handle with slots in a bracket with a flat spring) the real attack angle was not easily delt with. Our 3-14s on a 350U and neighbors 350UD were used on fields which were radically variable from edge to edge/end to end. Depth adjustment was nearly a continuous project. (due to poor draft control) A 400 (early) with an angle of implement control was way more adjustable and had no draft control named as such. Later 400s and 450s did and they were not much help, as they were the D handled style, and sensed very little, and made little difference whether in full up or full down position on the lever. Using it to keep it from tipping over when the plow was removed from the tractor was the wheels main function for us. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.