yes jim, I know exactly what you are referring to. but where shims are used correctly is between the rod and cap halves. then as wear indicates shims are removed. I have also seen brgs with shims inbetween the brg and cap. but this is not actually the correct way to go about correcting clearance. this is even interrupting the brg. crush as it has to fit snuggly to the cap and for heat transfer also. about the same thing as using silicone or glue on a loose sleeve. it will not transfer the heat properly. you don"t want the brg. moving around in the cap. as you say it is kind of the last resort fixes. to fix the problem the rods need to be resized to original spec"s. it is not that expensive of a job either.then the brg fits properly instead of trying to match the egg shape of the rod. rod checking and resizing is often overlooked. in this case we have so little info here and the guy is not offering to help with more info. my comment about useless idea on wk40"s is that the shims have caused more grief than benefit. they were never adjusted correctly and resulted in more engine failure. trying to explain shims to some guys they are lost and don"t understand the purpose of them. shims are there to be taken out as parts wear not added to worn parts. don"t mean to be sounding negative but I have made things work also in a bind and do know when things will and will not work. we still don't know if he is talking brg. clearance or rod side clearance. I have a feeling it is side clearance though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
