Farmall & IHC Tractors Discussion Board |
Cam Timing
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ace Schrunk on December 17, 2000 at 16:44:05 from (205.188.197.58):
With so maney old tractors being restored the question has come up I do I check cam timing with out taking off timing cover. There is a way for 4 & 6 cylinders. I only have information for the 4 cylinders now will post 6 latter. ! turn no 1 cylinder TDC, from the front of the engine valve 1&2 should have clearence, also valve 3 7 5 should have clearince, then turn engine 180 degrees to TDC valves 8,7,6 & 4 should have clearence. I use to use this for seting the valves back in the 60,s & 70,s you can use to set valves and save time turning engine for each cylinder. If the cam is off just 1 tooth you will be able to hear it when the engine runs so iof cam was not set by the timing marks it would be hard to get cam off 180 degrees so 4 would be no 1 as some one asked. As I said I will get the right info for the 6cyl this is go for all with 1342 order and the 6 good for 153624 order
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|