Farmall & IHC Tractors Discussion Board |
braggin a little
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MikeH-Tx again on December 16, 2000 at 13:01:13 from (199.170.89.80):
OK, so this isn't in the same category as some of the machine work done on tractor restoration, but for me it is pretty good. When I disassembled the clutch in my F12, I found it had the older 8in clutch instead of the newer 9in, making parts a little scarce. Two of the three fingers that the throwout bearing pushes on to disengage the clutch were worn down to nothing. Worn so much that the throwout bearing had rubbed a groove in one of the fingers, up by the adjuster. No big deal, just welded up an extension on the two fingers and ground them like the third one. Looks almost new. Might not wear as well as a new one, but should work. (original in the back of the picture, rebuilt ones in the front) Cool, huh?
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|