Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Hydraulic Valve SMTA
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dan on December 15, 2000 at 13:32:08 from (12.18.161.164):
In Reply to: Re: Re: Hydraulic Valve SMTA posted by Dick Davis on December 15, 2000 at 05:44:12:
On this one the remote valve sits under the right front corner of the fuel tank. It uses the same reservoir as the lift all which is under the rear part of the tank. The remote valve sits on a pipe on top of the center section over the TA and pto.(I think) It has the live pump in front of the distributor. I think these might have come that way. The oil lines go from the live pump to a T on the side of the remote valve. One side of teh T goes to the remote valve and the other outlet goes to the right side(input side) of the lift all valve and reservoir. Both pressure and return lines go through Ts on the remote valve then on to the lift all. It would seem to me that one should be able to use the remote valve and lift all interchangebly as both have pressure from the pump at all times or it would seem so. Not sure exactly what goes on in lift all valve though and don't ahve a good single action cylinder to check it out with. Hope my plumbint explanation makes sense. Not sure if this is original plumbing or was changed at some time as I just bought the tractor last summer. The remote valve is hooked to the cylinder on the 3 point at this time as it is a 2 way cylinder. Thanks for all the help
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|