Farmall & IHC Tractors Discussion Board |
Re: Farmall Super A tractor hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim Becker on December 14, 2000 at 14:11:07 from (208.24.179.202):
In Reply to: Farmall Super A tractor hydraulics posted by Tom Olson on December 12, 2000 at 21:09:46:
The diverter block is probably the most clean way to do what you want. Before you spring for the cost of the block, you can test the speed etc. for nothing but your time (plus whatever oil you spill). This assumes you currently have compatible hydraulic fluid in the Touch Control and the loader. Remove the hoses from your PTO pump. Connect the pressure hose to the pressure tap on the small casting where the diverter valve goes. It will be the plug next to the smaller tube. Connect the return hose to the Touch Control filler plug. Run a Touch Control arm back and chain it in place. Push the control lever forward. The loader should work.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|