Posted by Redturbo on January 04, 2014 at 09:47:24 from (66.112.187.143):
Couple years ago, friend of mine sold his acreage. Moved to town. Get a call, I know your into old red tractors. I left one at my old place, its free. No idea what I was getting, took truck & trailer. Told it died where its sitting. Its a 1957 W450 with a front end loader. So I winched it onto the trailer & towed it home 18 miles. Cut the loader off, took to dump. It wasn't worth saving, already have an IH 560D loader tractor. My shop is finally done, towed the W450 inside.
The wiring of the W450 is a rat's nest. Replaced the coil & ran couple wires to make it run. Got engine to turn over & have spark. Poured gas in the cylinders, its came to life. Cleaned sediment bowl out, same as gas tank. Poured some gas into tank, started to run out of carb. Then it quit leaking. It the button & came to life!
Great I thought, this is going to be the snowblower tractor. Found a 4ft front mount snowblower of local ads. Finally got brackets made up last night. It will barely move a 3" x 12 ram to move the blower. I can just push the blower around, so its not that heavy. When New Holland sold this snowblower for there tractors, ram was only a 2" ram.
The engine loads up when trying to move the ram, both lines get smoking hot when using hydraulics. Oil level is good, checked that. Going to take screen out of bottom of tank. I read about screen & orifice in the safety/regulator valve. Where is this? Would that be my problem? Not sure how this tractor ran a loader with 4 rams. But its been sitting for couple years now.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.