Posted by mkirsch on January 02, 2014 at 05:40:03 from (70.215.5.228):
In Reply to: Front End Loader posted by Atilathehun99 on January 01, 2014 at 14:45:05:
Odds are the owner will want to keep the auxiliary control valve on his C because otherwise he will have no hydraulics at all. The hydraulic lines from the pump are part of the valve. It's also pretty handy for other purposes.
If it's set up with a bypass block and a separate valve, you might be able to convince him to include it with the loader. A bypass block can be identified because it bolts in between the hard steel lines and the hydraulic unit under the gas tank.
The auxiliary tank setup is very simple. All it has to be is mounted at a level above the fill hole on the block under the gas tank. You connect a hose from the auxiliary tank to the fill hole on the block. That's it. A gallon is plenty.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
