Posted by F-Dean on December 31, 2013 at 05:14:46 from (70.209.10.115):
In Reply to: F-4 Mag posted by Mark Poss on December 31, 2013 at 03:54:53:
It is not hard. 1. Remove the distributor cap and note the position of the brass "distributor." Remove the mag from tractor. DO NOT TURN THE ENGINE UNTIL YOU HAVE REINSTALLED THE MAG. 2. Take out the 2 screws that hold the strap on top and pull the U-shaped magnet up and off. Note, or mark, which way the magnet is mounted - usually with a IHC logo on the outside. 3. Remove the 4 screws holding on the top cover. (They screw from the bottom up.)and remove the top cover. 4. Replace the condenser and re-assemble. You may want to replace the coil while you have the mag apart-easy but expensive ($50)
You can kill the engine by grounding the condenser so I drill a small hole in the mag cover, run a piece of 14-gauge automotive wire thru the hole and connect the wire to the condenser. After remounting the mag, I connect this wire to a one-wire on/off switch from a letter series tractor for a simple way to kill the engine.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.