Farmall & IHC Tractors Discussion Board |
Re: Farmall Super A tractor hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on December 13, 2000 at 04:16:54 from (63.42.174.193):
In Reply to: Farmall Super A tractor hydraulics posted by Tom Olson on December 12, 2000 at 21:09:46:
yes it requires the lines from the pump to the casting BUT take the two plugs out of the block that bolts to the rockshaft housing use them GPM will not be as good as the CHARLYNN you are using but have seen loaders used of these holes aint no reason the line assy could not be remaved and make these holes 3/8 pipe this would increase the gpm go for it why dont you buy another A FROM ME AND THEN WONT HAVE TO CHANGE AROUND UNUTS har har har do have some for sale west of CHICAGO 250 a little warmer here not to damn much still below xero
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|