Posted by Ben MacLeod on December 26, 2013 at 15:00:27 from (24.215.114.134):
Been having hydraulic problems with this tractor and removed the MCV to diagnose. I found a broken spring in the oil cooler bypass valve. I replaced it and the gaskets and put everything back together. It did not fixed my weak hydraulics but my previously working PTO stopped working. It was very strong even when the hydraulics were weak. I have since discovered blown seals in my pump (only 1 year old) and have restored my hydraulic pressure.... but the PTO still will not engage. I took the IPTO pressure line off at the MCV and only a trickle of oil is coming out with the PTO lever engaged. I can stop it easily with my finger. I dont have a pressure gauge but I know this is no where close to 220PSI. I pulled out the PTO regulator and verified there is no broken spring etc, and I also pulled out the IPTO control valve to verify the existence of all parts and springs and replaced it. I'm not great with hydraulics... anyone have any ideas?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.