Farmall & IHC Tractors Discussion Board |
Help!!! Super M Engine oddity
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Pete on December 12, 2000 at 16:35:50 from (205.188.200.33):
Self taught on Ford & Deere, but just getting started on IHC (except simple tune ups on the Super C over the years.) Father and I found a '53 Super H and a 54 Super M complete and the right$ so... SH coming good, but SM had a bad skip/back fire which I assumed was a stuck valve, when I threw a tune up in her I saw that previous owner had the plug wires wrong, order 4-2-3-1, tuned it, checked to see if dist was 180 out, wasn't, changed to 1-3-2-4 order, timed her, wont fire at all. Put wires back , started again, but same symptoms? Any ideas? If the cam was not timed to the crank properly would this happen? I guess that's the next attack unless I hear different. thanx!
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|