Posted by Janicholson on December 15, 2013 at 16:05:24 from (74.60.94.18):
In Reply to: cub pistons posted by Brandon J on December 15, 2013 at 15:30:44:
If the ridge is at or less than .0035" Diametric change compared to the bottom of the cylinder, removing the ridge with a ridge reamer and glaze breaking with a bead breaker will be doable. If more than this (up to maybe .006) it can be straight honed, and the pistons can be re-sized by Knurling to fit. There are few shops setup to knurl pistons. They will be nervous that they will either break a piston knurling it, or that the job won"t last, or that it will still have piston slap. You might have to sign a waver to get it done. An alternative is to have the block bored out and repair sleeves installed to return it to original diameter. This works well, and is common practice. It is more expensive, but the issue is correctness to keep it in good reliable operation. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.