Posted by fixerupper on November 30, 2013 at 16:20:27 from (100.42.83.15):
The voltage regulator on my B is some kind of a conversion regulator my IH dealer sold me to take the place of the cutout. The regulator has a long skinny resistor screwed on to the field terminal, going straight up and the field wire from the genny is screwed onto the resistor mid-way up on the resistor. The regulator quit working and I've been playing around with it trying to breathe a little more life in to it. The genny charges fine when the field terminal is grounded with a jumper wire. Do any of you know anything about this setup? Is this just a standard 6V regulator with a resistor screwed onto the field terminal or what? I have not taken the resistor off of the field terminal and tried bolting the field wire from the genny straight to the field terminal on the regulator yet. Ran out of time. If it's this resistor that's bad and the regulator is still good do any of you guys know what value of resistor will work? Lots of words for a simple question. LOL Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.