Steve706, It's a relatively simple system, so it won't be too hard for you to figure out. Seeing as you say you have NO power to anything, it rules out all the minor stuff. If you have a meter it will be a bit more informative, but even a 12V bulb on pigtails will give you solid clues.
First, check the battery at the terminals - a bulb should glow brightly, or a meter show at least 12.6V (half that if it's a 6V system). Next, move just the grounded test lead to some point on the chassis - it should show the same as on the battery itself. If it doesn't, you have a bad ground connection between the battery and chassis. If it shows good, then move the "high" side test wire to the battery stud of the starter. If it doesn't show good, you've a bad connection on that side of the battery. Not that this next step applies to the 100, but with any tractor that starts from the key switch (rather than a starter rod), if you have power at the starter stud and chassis but nothing beyond (like lights) the probable fault is in the "fuseable link" - the smaller, usually 10 AWG wire that goes from the starter stud to the ammeter and the rest of the electrical stuff on the tractor. Some of them are actually fused! Most from the 40's to 60's aren't.
Yes, battery connections can give out 'just like that', and usually, it's the positive terminal that needs the cleanup, be that the grounded or high side of the system. If the battery clamps have been replaced, there is a chance that the wire clamps have a bad connection.
Hope that helps. If not, let me know and I can walk you through a more through set of tests.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
