Posted by mkirsch on October 28, 2013 at 06:54:07 from (64.80.110.74):
In Reply to: Ih 460 posted by Farmall tom on October 26, 2013 at 17:11:15:
I've seen this before.
If it does not shift when you pull the lever, and does not stop when you pull the lever, the TA clutch is burned out.
Whoever adjusted it last before you had it made the linkage between the clutch rockshaft and TA rockshaft too short, so the TA clutch has been slipping and slowly burning up.
The TA is supposed to shift into low range whenever you push the clutch. This is so you can shift the tractor. But, the TA should shift back into high range by the time you get the clutch pedal about half way back, long before the tractor starts moving.
This can NOT be adjusted out. You need to split the tractor to replace the TA clutch and throwout bearing. It's much easier and less expensive than replacing the whole TA, at least.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
