Now i may be wrong on this BUT they were only used on tractors with fast hitch that did not have the drawbar and used the fast hitch draw bar . IF you did not use the lock out brackets with a fast hitch draw bar while using any PTo drive implement there was a chance of the drw bar being pushed up and snapping off the PTo shaft or while pulling a heavy load the draw bar could be shoved way up and cause the tractor to be shoved over by the load while going down hill. My 806 is and early one with fast hitch and has them but i have the under slung draw bar with draw bar support and i never use mine . NOW my one friend has a early 806 with fast hitch and no under slung draw bar and he does not use his and we will not go into how many PTO 540 shafts that i have had to put in his over the years Due to him bumping the control lever by accident or by the two implement pushing up on the fast hitch . But my advice is to just get a underslung draw bar and the bracket for that draw bar and for get about the brackets UNLESS you going to tractor pulls and pulling off the fast hitch .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
