hmm.. all of the tractors here are earlier than 20381, but looking at the parts book TC-100 revision 9 issued 2-'71, the later rear frame, 390965r21 also calls for 2 of 444788 plug, 1/2-14 auto sq-soc pipe and 1 of 9409949 plug, 3/4-14 auto sq-soc pipe whereas the earlier rear frame 380361r21 does not. here's another puzzle- the note under 380361r21 reads: order frame, 390965r31 & two cases, 392075r1
notice the part numbers. it wasn't a change from r1 to r2, it was a different number. the way the system works is a change from r1 to r2 of the same number means the parts are interchangeable but updated.
as for your problem, it doesn't seem like IH to change the bolt pattern for no good reason, but you never know. are you SURE you got the right lockout brackets? the ones i've got have 4 holes but you only use 3 and i think you can rotate them any way cause it's a square bolt pattern.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.