Farmall & IHC Tractors Discussion Board |
whats the best pistons/sleeve and piston kit for a 450
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by shannon on December 05, 2000 at 19:09:15 from (199.224.85.118):
i am ready to rebuild my ever-weakening (bad rings) 450 this winter and was wondering what i should do. i would like to get a lot more power than stock, but keep it pretty "mild" because it will still see alot of farm use and only be pulled a few times a year. i was thinking of a bigger bore and higher compression. is there anyone who sells a good overbore sleeve and piston kit or should i just get the high altitude pistons and keep the stock bore? what is the compression of the high altitude pistons? also what is the biggest bore i could go without having to bore the block to fit the bigger sleeves. anything else simple i should know about that will make power? thanks.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|